2018112-003 Rev J eBike, eBike L, eBike EL - 59 -
D: Service Menu
ebike: Note: After the update is complete the message
"Software Update - FW 1.8 - Update finished -
Switch off power" is displayed.
eBike: After a successful update, turn the ergometer off and on
again and check the software version in the menu
- Software Version FW 1.8.
Note: During the software download procedure, please do not
switch off the eBike and PC and do not disconnect the
download cable.
Note: If the update is unsuccessful, it can be repeated.
If a failure happens while the file MRD download is in
progress and the eBike is switched off, follow the “Update
Troubleshooting” or replace the complete PCB RPM, part
no 2018111-034.
Note: If the second attempt falls as well, we recommend to
proceed according to “Update Troubleshooting”:
Note: The new RPM 2 Board works only with software FW1.6 and
higher.
Important:
No downdates are permitted once version FW 1.8 has been
installed!
To Next Page
Loading...
