– 11 –
NOTES:
• The previous chart has maximum segment parameters listed. The control will bypass some rinse cycles
if the turbidity sensor detects lower soil than the selected cycle maximum parameter and temperature
targets are met.
• Selecting the Wash Temp option will add 5 minutes to Pre-Wash 4 (PR4) and Post-Rrinse 1 (PW1). This
extra time is used to heat water.
• The Steam option will change the segments Pre-Wash 4 (PW4), (increasing heater operation).
• The Bottle Wash option (some models) may increase the cycle time, adding up to 23 minutes; water
usage does not change.
• Circulation has built in pauses (see Diverter, Operation in the Circulation System section of this guide).
• USA (Upper Spray Arm): When a number is placed before the USA, it indicates the approximate time in
seconds of operation.
• LSA (Lower Spray Arm): When a number is placed before LSA, it indicates the approximate time in
seconds of operation.
• PW: Pre Wash
• PR: Post Rinse
• FR: Final Rinse
Cycle Option Selected Light
Normal
Fixed
Normal
Sensor
Auto Heavy
All Zones
No
Options
49 - 72 76 75 110 147
Heated
Dry
113 - 136 124 123 174 211 - 235
Boost 140 111 134 157 - 181
Sani 185 155 170 202 - 225
Steam 104 118 137 157 - 180
Boost
Heated
Dry
204 175 198 221 - 245
Sani
Heated
Dry
249 219 234 266 - 289
Steam
Heated
Dry
152 182 201 221 - 244
Steam Boost 168 138 161 162 - 185
Steam Sani 212 182 197 207 - 230
Steam Boost
Heated
Dry
232 202 225 226 - 249
Steam Sani
Heated
Dry
276 246 261 271 - 294
One Wash Zone Selected
(some models)
No
Options
57 79 - 105 - 129
24% 28% 28%
Heated
Dry
105 143 169 - 193
Boost 78 109 115 - 139
Sani 132 149 170 - 193
Steam 90 106 122 - 145
Boost
Heated
Dry
142 173 179 - 203
Sani
Heated
Dry
196 - 254 213 - 252 234 - 257
Steam
Heated
Dry
154 - 213 170 - 209 186 - 209
Steam Boost 105 - 162 136 - 174 127 - 150
Steam Sani 159 - 217 176 - 215 182 - 205
Steam Boost
Heated
Dry
169 - 226 200 - 238 191 - 214
Steam Sani
Heated
Dry
223 - 271 240 - 279 246 - 269
Minimum and Maximum Times