Chapter 2: Operation
Page 22 HygroPro User’s Manual
2.2.2 Entering the Setup Program
To enter the setup program, complete the following steps:
Using the arrow keys, highlight the
opened lock and press enter.
Select Passcode and press enter.
Note: The default operator-level passcode is 2719.
Enter your passcode using the up and
down keys to change the value of each
passcode digit, and the left and right
keys to move from one digit to the next.
When the passcode is correct, press
enter.
Note: To enter the Service menu, the factory-level passcode must be
entered.
To Next Page
Loading...
