GE HygroPro - Setting up the RS485 Output

HygroPro User’s Manual Page 29
Chapter 2: Operation
2.2.7 Setting Up the RS485 Output
To set up the RS485 output, complete the following steps:
Enter your passcode to access the setup
program. Then use the arrow keys to
select the RS485 menu. Press enter.
To enter the Baud Rate, press enter.
Use the up and down keys to select the
desired value and press enter.
Repeat the above procedure to enter the following RS485 parameters:
• Parity
• Stop Bits
• Data Bits
You have now completed the initial setup process.