HygroPro User’s Manual Page 23
Chapter 2: Operation
2.2.3 Selecting Measurement Parameters
To select the measurement parameters, complete the following steps:
To select the number of measurements to
be displayed on each screen, select
# of Views and press enter.
Use the up and down keys to select the
number of views desired and press
enter. Then, press enter again to return
to the previous menu.
Press escape to see the view setup. To
change a measurement parameter, use
the arrow keys to highlight the parameter
name and then press enter.
Use the up and down arrow keys to
select a measurement parameter and then
press enter twice.
Note: As an example, Dew Point has been selected as the
measurement parameter to be changed.
To Next Page
Loading...
