Chapter 2: Operation
Page 24 HygroPro User’s Manual
2.2.3 Selecting Measurement Parameters (cont.)
Use the up and down arrow keys to
select a unit of measure and press enter
twice.
Repeat the previous steps to make any other desired measurement
parameter changes. Then, continue as follows:
• If the operator-level passcode was used, highlight the lock symbol
and press enter again to return to the DISPLAY menu.
• If the service-level passcode was used, continue the programming
steps below.
If the number of decimal places is
acceptable, press escape. To change the
number of decimal places, press enter.
Use the up and down keys to change the
number of decimal places and press
enter.
The programming sequence is now complete and you are returned to
the
View menu.
To Next Page
Loading...
