GE
Sensing
DECLARATION
OF
CONFORMITY
DOC-0001, Rev. A
We,
GE Sensing
1100 Technology Park Drive
Billerica, MA 01821
USA
declare under our sole responsibility that the
HygroPro Moisture Transmitter
to which this declaration relates, is in conformity with the following standards:
• EN 60079-0: 2000
• EN 60079-26: 2004
• II 1 G EEx ia IIC T4; Baseefa06ATEX0019X (Baseefa, Buxton, Derbyshire, UK - NoBo
1180)
• EN 61326-1: 2006, Class A, Table 2, Industrial Locations
• EN 61326-2-3: 2006
Other standards used:
• EN 50020: 2002
following the provisions of the 2004/108/EC EMC and 94/9/EC ATEX Directives.
Where products were initially assessed for compliance with the Essential Health and Safety
Requirements of the
ATEX Directive 94/9/EC using earlier harmonized standards, a subsequent review has
determined that “technical knowledge” is unaffected by the current harmonized standards
listed above.
The unit listed above and any ancillary equipment supplied with it do not bear CE marking
for the Pressure Equipment Directive, as they are supplied in accordance with Article 3,
Section 3 (sound engineering practices and codes of good workmanship) of the Pressure
Equipment Directive 97/23/EC for DN<25.
Billerica - August 2010
Issued Mr. Gary Kozinski
Certification & Standards, Lead Engineer
To Next Page
Loading...
