iBox/iBox Kit
Installation and Maintenance Guide
GE Grid Solutions
994-0047-5.10-4 GE Information
Configuring the Ethernet Module, continued
Procedure:
Configuring
the Digi One
(continued)
Step Action
20
Select your device.
Note: The MAC address of your Digi One IAP is located on the white
label on the bottom or back of the device.
21
Click Next.
Result: The Configure Network Settings page appears:
Configure the Digi One IP Settings
22
Select Use the following IP settings.
23
Enter the Digi One Ethernet IP address and subnet mask, as shown in the
above example. Enter a gateway address if one is required. Check with
your network administrator if you are not sure.
Continued on next page
To Next Page
Loading...
