ge.com
"F- anda number
orletter"flash
in thedisplay
Possible Causes What ToDo
You have a function
error code.
• Disconnect all power to the range for at least 30
seconds and then reconnect power. If the flmcfion
error code repeats, call for service.
• Oi1 self-cleaning models, if a flmction error code
appears during tile self-cleaning cycle, check tile oven
door latch. Tile latch may have been moved, if only
slightly, from tile locked position. Make sure tile latch
is moved to tile right as far as it will go. Touch tile
Clear/Off pad. Allow tile oven to cool for one houL
Put file oven back into operation.
Display flashes "bAd" The installed connection • Contact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone is miswired.
Display goes blank A fuse in your home may be • Replace tile fi_se or reset tile circuit breakeL
blown or the circuit
breaker tripped.
The clock is turned off from • See tile Using the clock and timer section.
showing in the display.
Display flashes Power failure. • Reset the clock.
Unable toget the Oven control pads were • Tile Bake and Broil Hi/Lo pads must be touched
display to show "SF" not pressed properly, at tile same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset tile clock. If tile oven was in use, you must reset
clock flashes it by touching tile Clear/Off pad, setting tile clock
and resetting any cooking flmction.
"Burning" or "oily" This is normal in a new • To speed tile process, set a self-cleaning cycle
odor emitting from oven and will disappear for a minimmn of 3 hours. See tile Using the
the vent in time. self-cleaning oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
25
To Next Page
Loading...
Need help?
General
