Usingthe clock andtimer, ge.com
Not all features are on all models.
i ii _i
ii i i:
l%tortQ
k °n )
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to file correct time
of day for tile automatic oven timing
flmcfions m work properly. Tile time of
day cannot be changed during a delayed
cooking or a delayed self-cleaning cycle.
[] Touch tile Clock pad twice.
[_ Touch tile + or - pads.
If the + or - pads are not touched within
one minute after you touch tile Clock
pad, tile display reverts to tile original
setting. If dds happens, touch tile Clock
pad twice and reenter tile time of day.
[_] Touch tile Start/On pad until tile
time of day shows in tile display. This
enters tile time and starts tile clock.
Tocheckthetimeofdaywhenthedisplayis
showingotherinformation,simplytouchthe
Clockpad.Thetimeofdayshowsuntilanother
padis touched.
To Turn Off the Clock Display
If you have several clocks in your kitchen,
you may wish to turn off tile time of day
clock display on your range.
[_ Touch tile Clock pad once to turn
off tile time of day display; Akhough
you will not be able to see it, tile
clock maintains tile correct time
of day.
Touch tile Clock pad twice to recall
tile clock display:
O
(_tchen_
kZim
On/Off
The timer is a minute timer only.
The Clear/Off pad does not affect the
timer.
To Set the Timer
Thetimerdoesnotcontrolovenoperations.
Themaximumsettingonthetimeris9 hours
and59minutes.
Touch tile Kitchen timer On/Off pad.
Touch file + or - pads until tile
amount of time you want shows in
tile display. Tile maximum time that
can be entered in minutes is 59.
Times more than 59 minutes should
be changed to hours and minutes.
Ifyoumakea mistake,touchtheKitchen timer
On/Offpadandbeginagain.
%
Touch tile Start/On pad. Tile time
will start counting down, akhough
tile display does not change un61
one minute has passed.
x_qlen tile timer reaches :00, tile
control will beep 3 times followed
by one beep every 6 seconds until tile
Kitchen timer On/Offpad is touched.
To Reset the Timer
If file display is still showing file time
remaining, you may change it by touching
tile Kitchen timer OR/Offpad, then
touching tile + or - pads until tile time
you want appears in tile display.
If die remaining time is not ill file display
(clock, start time or cooking time are in
file display), recall file remaining time by
touching file Kitchen timer On/Off pad and
dlen touching tile + or - pads to enter tile
new time you want.
To Cancel the timer
Touch tile Kitchen timer On/Off
pad twice.
77
To Next Page
Loading...
Need help?
General
