KTD-405/405A/405-2D Keypad
Quick Guide
11
Standard key functions
mon Press to select monitor.
Press and hold for three seconds
to view keypad information.
0 to 9 Use in combination with other
keys to select cameras, monitors,
zones, presets, etc.
esc Refresh the monitor display.
Clear an alarm.
Clear a number entry if required
number of digits are not entered.
esc+[key] for shifted function.
esc+mon for key function help.
esc+iris (plus or minus) to
change the backlight brightness
on the keypad display.
Press and hold until you hear a
tone to enter the password menu
and begin programming mode.
1st Press to call up the first site in the
annunciation queue.
autofocus Press to place the selected
camera in autofocus mode.
aux X Field programmable keys for
various site-specific applications
(the default assignment is printed
above the keys.
seq Select a multiplexer/switcher
sequence tour on the active
monitor.
alarm In Digiplex mode, toggle alarm
mode between on and off for the
current monitor.
In zone mode, clear all alarms.
store Press store, <preset number>,
store to store presets.
Press store,
or , store to
set autopan limits.
Press store, seq to access
sequence programming for
Calibur multiplexers (zone mode
only).
Press store, [aux 1 to 4], store to
store preset positions 58 to 61.
tour Press tour <tour number> to
place a PTZ receiver in tour
mode. Press tour and hold until
you hear a tone to set autopan
mode for the current camera.
find Press find <number keys> to
view preset camera positions.
Press find, [aux 1 to 4] to view
preset positions 58 to 61.
+ zoom - Controls the zoom function on
selected receiver site’s motorized
lens.
+ focus - Controls the focus function on
selected receiver site’s motorized
lens.
Temporarily disables the
autofocus feature on a GE PTZ.
Any joystick movement enables
the autofocus.
+ iris - Controls the iris function on the
selected receivers site’s
motorized lens.
To Next Page
Loading...
Need help?
General