KTD-405/405A/405-2D Keypad
Quick Guide
6
Switcher and monitor operation
Switcher control
To view a camera on a specific monitor, at
the default keypad menu, enter the
monitor number then the camera number.
To initiate a camera sequence tour, press
seq , <sequence routine number 1 to 7>.
To initiate a group sequence, do the
following:
1. Press esc and zone.
2. At the prompt, press tour.
3. At the prompt, enter the group
sequence number. For single digit
numbers, press <number key>, . For
double digit numbers press <first digit
key>, <second digit key>.
To enable or disable the alarm mode for a
monitor, press alarm. If the alarm mode is
enabled, A appears on the affected
monitor.
Monitor selection
There are two ways to select a monitor. For
example, to select monitor 1, do one
of the
following:
•Press mon, 1, .
• Depending on the number of monitors
in your system, press one of the
following:
•Press 1 (1 to 9 monitors).
•Press 0, 1 (10 to 99 monitors).
•Press 0, 0, 1 (100 to 128 monitors).
Sequence tours. In order to view
sequence tours, your system must
include a KTD-440 and you must
program the KTD-440 with one or more
sequence routines.
Group sequences. In order to initiate a
group sequence, you must first program
the sequence at the matrix switcher.
To Next Page
Loading...
