KTD-405/405A/405-2D Keypad
Quick Guide
5
PTZ camera operation
Camera selection
There are two methods for camera
selection. For example, to select camera 1,
do one of the following:
• If you have fewer than ten cameras,
press 1. If you have tens of cameras,
press 0, 1. If you have hundreds of
cameras, press 0, 0, 1. Or
•Press 1, .
Preset programming
To program presets, move the camera to
the desired position and do the following:
Standard presets. Press store, <preset
number>, store to store presets.
Autopan limits. Press store, or ,
store to set autopan limits.
Quick store. Press store, [aux 1 to 4],
store to store preset positions 58 to 61.
Preset selection
To move a PTZ camera to a preset position,
press find then <preset number>.
Tour initiation
To initiate a previously programmed tour
on a PTZ camera, press tour then <tour
number>.
Presets. PTZ cameras can store up to
32 (numbered 00 to 31) or 64 (numbered
00 to 63) preset positions, depending on
the camera model. Preset numbers 62
and 63 are reserved for autopan limit
settings.
If you intend to reprogram a large
number of existing presets, we
recommend you clear all presets stored
in memory.
To Next Page
Loading...
Need help?
General