KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
22
Supervisor programming
As explained in Entering programming modes on page 21, to enter the supervisor menus, from the ENTER
PROGRAMMING CODE menu, press 1-4-7-6-seq.
Note: This is the default factory supervisor programming code sequence. After you install your KTD-405 keypad, be sure to
change the supervisor programming code as soon as possible to avoid security problems. To change the programming code,
see Figure 27 on page 26 of this menu. This is a critical number since it is needed to change any of the access codes. Be sure
to store the new number in a safe place. If the number is lost, GE Security technical support can help you reset the keypad to
factory defaults. All keypad setup information will be lost.
1. At the first menu in supervisor programming mode, you have the option to erase the keypad’s
nonvolatile memory and reload factory values. If you chose YES, you have these further options:
RESET ALL. Resets all stored settings to factory default.
RESET ALL BUT TITLES. Retains the zone titles, but sets everything else to factory defaults.
CAMERA. Access the camera you want to reset before you enter the supervisor programming.
Selecting this will send a reset to the camera. This is for resetting or restarting GE PTZs, not for
clearing settings. (16x, CyberDome2, and Legend)
Pressing forwards you through programming without changing set parameters.
To skip this menu and go to the next, press - or
.
Figure 17. Supervisor programming menu tree
Note: All PTZ's that are capable will reset when you send this command.
RESET TO DEFAULTS?
NO
PARTIAL. ARE
YOU SURE?
RESET CAMERA X ?
ARE YOU SURE?
COMPLETE. ARE
YOU SURE?
1 = RESET ALL BUT
TITLES
INITIALIZING
DEFAULTS
KEYPAD ADDRESS: 99
(01-99)NEXT
To Next Page
Loading...
