Chapter 4
Operation
51
Programming a DVMRe/multiplexer camera sequence
If you are using a Calibur DVMRe/multiplexer, set a camera sequence by doing the following:
1. Press store.
5. Repeat step 4 until all cameras in the sequence have been entered.
6. Press .
Note: Pressing seq toggles between sequencing and not sequencing.
2. Press seq. to display the ENTER
SEQUENCE menu (Figure 62).
3. Enter the number of the first camera in the
sequence.
4. Wait the amount of time you want between
cameras, then press the next camera in the
sequence.
Figure 62. Enter sequence menu
ENTER SEQUENCE
CAMERA
To Next Page
Loading...
