GE LOGIQ F SERIES
DIRECTION 5446617-100, REVISION 10 BASIC SERVICE MANUAL
8 - 8 Section 8-5 - Loading Base Image Software
Section 8-5 Loading Base Image Software (cont’d)
6.) Select one of the options for loading the system. Select choice 1] to load the complete disk.
7.) Press any key to continue when below message display as shown below.
Figure 8-16 Selection for loading the system
WARNIN
While the software install procedure is designed to preserve data, you should select
choice [2] to format disk C only.
Figure 8-17 Upgrade continue message
To Next Page
Loading...
