General procedures
LOGIQ V2/LOGIQ V1 – Basic Service Manual 4-11
5610739-100 English Rev.10
Logging on to LOGIQ V2/LOGIQ V1 as “ADM”
Select Utility -> Admin -> System Admin.
It will bring up the Operator Login dialog where you must log
on.
Figure 4-4. Operator Login Window
1. Operator: Select the operator.
2. Password: Enter Operator’s password (optional).
3. Select the type of Login or Cancel.
• OK: Standard login.
• Cancel: Cancel login.
As default, two users are defined, USR and ADM.
• USR
If you log on as USR, you will have access to do set-up tasks
that a user may need to do during daily use.
• ADM
If you log on as ADM, you will have access to do general set-up,
service adjustments, adjust network and connectivity settings.
Select the name ADM, the password and select Login.
It is possible for the administrator (ADM) to establish new users
and set unique passwords for each user, including a new
password for ADM. If the login as ADM fails, contact the
responsible person in the hospital to get access.
To Next Page
Loading...
Need help?
General
