i-20 LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10
Authorized Representative- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1-29
Chapter 2 — Site Preparations
Overview
Contents in this chapter- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-2
General Ultrasound system requirements
Contents in this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-3
Ultrasound system environmental requirements- - - - - - - - - - - - - - - - - - 2-3
Electrical requirements - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-6
EMI limitations - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-9
Probes environmental requirements - - - - - - - - - - - - - - - - - - - - - - - - - 2-11
Time and manpower requirements - - - - - - - - - - - - - - - - - - - - - - - - - - 2-11
Facility needs
Contents in this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-12
Purchaser responsibilities - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-13
Required facility needs - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-14
Desirable features- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-15
Minimal floor plan suggestion- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-16
Recommended floor plan suggestion - - - - - - - - - - - - - - - - - - - - - - - - 2-17
Suggested floor plan, Ultrasound system, and EchoPAC PC in same
room - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-18
Networking setup requirements - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2-19
Environmental Dangers
Patient Environment IEC60601-1 and ANSI AAMI ES60601-1 - - - - - - 2-22
Chapter 3 — System Setup
Overview
Contents in this chapter- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-2
Setup reminders
Average setup time - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-3
Setup warnings- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-3
Receiving and unpacking the equipment
Purpose of this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-6
Contents in this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-6
Warnings for receiving and unpacking - - - - - - - - - - - - - - - - - - - - - - - - 3-6
Receiving the LOGIQ V2/LOGIQ V1 - - - - - - - - - - - - - - - - - - - - - - - - - - 3-6
Unpacking the LOGIQ V2/LOGIQ V1 - - - - - - - - - - - - - - - - - - - - - - - - - 3-8
Packing the Equipment - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-11
Packing materials - recycling information
Preparing for setup
Verify customer order - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-13
Physical inspection - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-13
EMI protection - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-13
Completing the setup
Purpose of this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-14
Contents in this section - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-14
System specifications - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-14
Electrical specifications - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3-15
Peripheral/Accessories Connector Panel - - - - - - - - - - - - - - - - - - - - - 3-16