Important conventions
LOGIQ V2/LOGIQ V1 – Basic Service Manual 1-7
5610739-100 English Rev.10
Safety precaution messages
Various levels of safety precaution messages may be found on
the equipment and in the service information. The different
levels of concern are identified by a flag word that precedes the
precautionary message. Known or potential hazards to
personnel are labeled in one of three ways:
• DANGER
• WARNING
• CAUTION
NOTE: Notes are used to provide important information about an item
or a procedure.
NOTE: Be sure to read the notes; the information contained in a note
can often save you time or effort.
Danger is used to indicate the presence of a hazard that will
cause severe personal injury or death if the instructions are
ignored.
Warning is used to indicate the presence of a hazard that can
cause severe personal injury and property damage if
instructions are ignored.
Caution is used to indicate the presence of a hazard that will or
can cause minor personal injury and property damage if
instructions are ignored. Equipment damage possible.
To Next Page
Loading...
Need help?
General
