Loading the software
LOGIQ V3/V5/V5 Expert – Basic Service Manual 8-25
5726264-100 English Rev.8
8-3-8-1 Software Version check out
8-3-8-1-1 Functional Check-out
1. Power on LOGIQ V3/V5/V5 Expert system and wait until
system booting to scanning screen.
NOTE: If selected to load C Disk only when loading the system
software, the system will display a screen to restore
Computer name before entering the scanning screen.
2. Press Utility on the control panel.
3. Select the System -> About and check whether the
software version is right.
Figure 8-22. Software version
To Next Page
Loading...
