350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL 3–1
350 Feeder Protection System
Chapter 3: Interfaces
Digital Energy
Multilin
Inter faces
There are two methods of interfacing with the 350 Feeder Protection System.
• Interfacing via the relay keypad and display.
• Interfacing via the EnerVista SR3 Setup software.
This section provides an overview of the interfacing methods available with the 350 using
the relay control panels and EnerVista SR3 Setup software. For additional details on
interface parameters (for example, settings, actual values, etc.), refer to the individual
chapters.
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
