Page 23
LOCATION 51
AUTOTEST CONTROL
4 segments, numerical data
Segment 1
Program a "1" if the interval is to be in hours. Program a "0" if in days. Program a A2" to
suppress the daily test or a A3" to suppress the hourly test if any report has been sent.
Segment 2
Program the Autotest interval from 1-255 hours/days.
Segment 3
Program the Autotest report hour in 24-hour format (if the interval is in hours, this segment is
ignored).
Segment 4
Program the Autotest report time, number of minutes after the hour.
LOCATION 52
OPENING TIME
2 segments, numerical data
Location 52 contains the time in 24 hour format the NX-6 enables codes designated as arm only after closing. This time
is only valid on those days programmed in location 54. Note: Opening time must be earlier than closing time for
Auto Arm, Auxiliary Outputs, or Code Authorization to function properly.
Segment 1
Program the hour of the opening time.
Segment 2
Program the minutes after the hour of the opening time.
LOCATION 53
CLOSING TIME/AUTOMATIC ARMING TIME
2 segments, numerical data
Location 53 contains the time in 24-hour format the NX-6 disables the disarm capability for codes designated as arm only
after closing. This is also the time the Automatic Arming sequence will begin (if enabled in location 55). Note: Opening
time must be earlier than closing time for Auto Arm, Aux. Outputs, or Code Authorization to function properly.
Segment 1
Program the hour of the closing / auto arm time.
Segment 2
Program the minutes after the hour of the closing / auto arm time.
LOCATION 54
DAYS OF WEEK EACH PARTITION IS OPEN
2 segments, feature selection
Location 54 selects which days of the week each partition is open. On these days, Aarm only after close window@ codes
will be able to arm and disarm during open window. NOTE: If any partition is not programmed to be opened and
is programmed to Auto-Arm (Location 55), the NX-6 will try to arm every 45 minutes for the duration of the
closed period. On days not selected here, Aarm only after close window@ codes will not disarm. Segment 1 is for
partition 1, and segment 2 is for partition 2. (See locations 52 and 53 for the opening and closing times for the
open days.)
Segments 1- 2
â Open on Sunday.
ã Open on Monday.
ä Open on Tuesday.
å Open on Wednesday.
æ Open on Thursday.
ç Open on Friday.
è Open
on Saturday.
é Reserved.
LOCATION 55
DAYS OF WEEK PARTITIONS WILL AUTO ARM
2 segments, feature selection
Location 55 selects which days each partition will auto arm. Segment 1 is for partition 1, and segment 2 is for partition
2. If a zone is faulted when the panel tries to auto arm, the zone will be bypassed.
Segments 1- 2
â Auto Arming on Sunday.
ã Auto Arming on Monday.
ä Auto Arming on Tuesday.
å Auto Arming on Wednesday.
æ Auto Arming on Thursday.
ç Auto Arming on Friday.
è Auto Arming on Saturday.
é Reserved.
To Next Page
Loading...
