GE NetworX NX-6V2 - Notices

NX-6V2 Control 47
XXII. NOTICES
(Applies to products which have the CE mark attached)
Declaration Of Conformity
Manufacturer’s Name: Caddx Controls
Manufacturer’s Address: 1420 North Main Street
Gladewater Texas 75647
EU Representative: Interlogix Europe
Product Identification
Product: NetworX
Model Numbers: NX-6V2
Brand: CADDX
R&TTE Directive
See EMC and LVD tests below
EMC Directive
EN50081-1
EN50130-4
EN55022
EN60950
EN61000-3-2
EN61000-3-3
LVD Directive
EN 60950: 1999-4 3rd edition
Means of Conformity
We declare under our sole responsibility that this product is in
conformity with Directive 1999/5/EC (R&TTE); Directive
73/23/EEC (LVD); and Directive 89/336/EEC (EMC) and
based on test results using (non)-harmonized standards in
accordance with the Directives mentioned.
Additional Tests
This equipment has been tested and found to comply with the
following standards (which are no longer required for
compliance).
Network Compatibility Declaration
We declare under our sole responsibility that this product is
designed to work with the networks in the countries marked
with a check () and may have interworking problems with the
countries that are not checked. Due to the inherent differences
in the individual PSTNs, certain software settings may need to
be adjusted on a country-to-country basis. If it is desired to use
this equipment on a network other than the one on which it
was originally installed, you should contact your equipment
supplier.
() Austria (_) Liechtenstein
() Belgium () Luxembourg
() Denmark () Netherlands
() Finland () Norway
() France () Poland
() Germany () Portugal
() Greece () Spain
() Iceland () Sweden
() Ireland () Switzerland
() Italy () United Kingdom
Telecom Approval Notice
This equipment has been approved in accordance with the
Council Decision 98/482/EC for pan-European, single terminal
connection to the public switched telephone network (PSTN).
However, due to the differences between the individual PSTNs
provided in different countries, the approval does not, of itself,
give an unconditional assurance of successful operation on
every PSTN network termination point. In the event of
problems, you should contact your equipment supplier in the
first instance.
Electrical Requirements
This device automatically adjusts to voltages within the range
of 230 V 50/60 Hz.
Fuse: Type T 200mA 250 VAC