NX1448E Icon Keypad Page 13
Trouble conditions are:
Tamper Hardware Low Battery Loss of Supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
“flashing” light for a short period of time, followed by a slow “flashing”
light.)
KEYPAD FUNCTIONS
ARMING YOUR SYSTEM IN THE “AWAY” MODE
AWAY is used when the user is away from the premise and wants the
interior protected.
Close all protected doors and windows. Step 1
• Ready icon will be on or flashing when all protected zones and
sensors are secure. NOTE
: If any zones are bypassed, a sensor
in that zone can be violated without affecting the ready icon.
• The security system will not arm if the not ready icon is on o
flashing.
• If the power icon is off, you have no AC power. Restore power i
possible. If not, contact your installing company listed on page 1
of this booklet for service.
Step 2 Enter your 4 or 6 digit user code to arm the system.
• The armed icon and exit light will illuminate.
• You may now leave the building.
NOTE
: The exit light will flash rapidly for the last 10 seconds of the exit
delay as a warning to the user that the exit time is about to expire. The
user may wish to disarm and rearm the system if more time is needed.
To Next Page
Loading...
Need help?
General