NX1448E Icon Keypad Page 23
SETTING THE KEYPAD LIGHTING
Step 1 Press [r]-[9]-[1].
Step 2 Press the [•] and [–] scroll keys to lighten or darken the
illumination behind the buttons and the LCD display. It is
usually easier to set this adjustment in a darkened room.
SERVICE MENU
The service icon will be “on” if the security system requires service.
If the service icon is “on”, press [r]-[2] to determine the service
condition. If a zone(s) is tampered, the tamper icon will flash and the
zone icon(s) will be on. If a zone(s) is troubled, the trouble icon will flash
and the zone icon(s) will be on. If the service icon is flashing, one or
more zone icon(s) will illuminate indicating what service(s) is required.
Press the [•] and [–] to scroll between tamper, trouble and other service
conditions. Call your service provider immediately for these problems.
The following table provides a list of what each icon means in a service
condition.
ICON PROBLEM
SYSTEM FAULT - Press the [1] key. The zone icon(s) that is
illuminated corresponds to the system fault(s) below:
1 Over Current Fault
2 Siren Trouble
3 Box Tamper
4 Expander Power
5 Expander Low Battery
6 Expander Box Tamper
7 Expander Trouble
8 Ground Fault
1
Note: Faults 1 & 2 are global in nature and will affect all
partitions of a multi-partition system. Press the [#] key to
return to the 1 of 8 service icons.
2 RESERVED
To Next Page
Loading...
Need help?
General