Page 20 NX1448E Icon Keypad
Step 7 When the partitions are assigned, press the [r] key. This returns
you to Step 2 previously mentioned. At this point you may enter
another user number to assign authority level. Repeat Steps 3 -
7 until you have assigned authority levels to all user numbers.
Step 8 Press the [#] key to exit the Assigning Authority Level Program.
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
Step 1 Press [r]-[0]. Keypad is now in the “Adjust Tone” mode.
Step 2 Pressing the [•] key will make the keypad sounder go to higher
tones, pressing the [–] key will make the keypad sounder go to
lower tones.
Step 3 When the desired tone is reached, press the [#] key to set this
tone and exit from the “Adjust Tone” mode.
CHANGE PARTITION – Optional
Step 1 Press [r]-[1].
Step 2 Press a NUMBER key between 1 and 8 to change partitions
momentarily.
Step 3 If no other key is pressed, it will go back to its standard
partition in ten seconds.
Step 4 If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1 Press [r]-[3]. The zone(s) that created the last alarm will be
displayed along with the alarm icon flashing on the keypad.
To Next Page
Loading...
