NX1448E Icon Keypad Page 19
ICON AUTHORITY LEVELS IF ICON 8 IS OFF
1 Reserved (Note: Do not change if on.)
2 Arm Only
3 Arm Only After Closing Time
4 Master Arm/Disarm (can program other codes)
5 Arm/Disarm
6 Bypass Zones
7 Open / Close Reporting
8
If this icon is on, this code is programmed as a
function code. Do not change! Press [#] - [#] to exit.
Step 5 Press the [r] key. The ready icon is on constant and instant icon
is on constant. This moves you to the partition enable. (The user
has access in partitions that are illuminated.)
Step 6 The illuminated numbers indicate each partition where the user
has access. To change any of the partitions where the user has
access, press numbers corresponding to areas where you want to
give the user access or deny access. (Example
: If zone icon #2
is lit, then the user is assigned access to partition #2. By
pressing the [2] key, the icon will go off, denying access to
partition #2. Refer to the following chart.
ICON PARTITIONS ASSIGNED
1 Partition 1
2 Partition 2
3 Partition 3
4 Partition 4
5 Partition 5
6 Partition 6
7 Partition 7
8 Partition 8
To Next Page
Loading...
Need help?
General