NX1448E Icon Keypad Page 21
Step 2 The ALARM MEMORY feature will flash those zones that
created alarms and will display steady those zones that were
bypassed during the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator
test, and/or a siren test. Alarms and reports will not
be sent, unless a
communicator test is performed at which time a test signal will be sent.
Step 1 Press [r]-[4]. The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the
siren.
RESET FUNCTION
This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers. Your system must be Disarmed to use the Reset function.
Step 1 Press [r]-[7]. Resets have now been performed.
Step 2 If the keypad begins beeping, the reset did not execute
properly. Enter your code to silence the keypad. Wait a few
minutes and repeat step 2 to attempt another reset. If the
keypad still beeps after repeated attempts, please contact your
installer.
SET SYSTEM DATE
Step 1 Press [r]-[9]-[6]. Enter Code icon will display.
Step 2 Enter a [“Master Code”]. The service icon will appear flashing.
Step 3 Enter the “Day of Week “
1=Sunday 3=Tuesday 5=Thursday 7=Saturday
2=Monday 4=Wednesday 6=Friday
To Next Page
Loading...
Need help?
General