GE Security
g
Bypassing zones
If you wish to bypass one or more zones, this must be done while the system is in the disarmed state. To
bypass zones, two procedures are possible:
Procedure #1: If you know the number of the zone to bypass, use the following steps:
Step 1 Press the [BYPASS] key.
Step 2 When the LCD prompts for a code (optional, if programmed), enter your user code.
Step 3 The bypass light flashes.
Step 4 Enter the zone number (each time 2 digits) of the zone(s) that must be bypassed.
(Example: to bypass zones 4 en 5, press [0][4][0][5].)
Step 5 Press the [BYPASS] key again.
Step 6 The bypass light will stop flashing and will illuminate.
Step 7 Pressing the [] [] scroll keys will display all bypassed zones. Press the [#] key to
exit this viewing mode.
Procedure #2: If you do not know the number of the zone you wish to bypass, use the following
steps:
Step 1 Press [*] []. The description for zone 1 will be displayed.
Step 2 Use the [] []scroll keys to browse through the custom descriptions for the zones
in this system.
Step 3 To bypass or unbypass a specific zone, press the [BYPASS] key while that zone is
displayed.
Step 4 When finished, press the [#] key to return to the code entry screen.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.
Group bypass
Step 1 Press the [BYPASS] key.
Step 2 When the LCD prompts for a code (optional, if programmed), enter your user code.
Step 3 The bypass light flashes.
Step 4 Press [0][0].
Step 5 Press the [BYPASS] key again.
Step 6 The bypass light will stop flashing and will illuminate.
Step 7 Pressing the [] [] scroll keys will display all bypassed zones.
Press the [#] key to exit this viewing mode.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.
NX-148E User manual Page 11 04/10/04
To Next Page
