GE Security
g
KEYPAD FUNCTIONS
Arming your system in the “AWAY” mode
AWAY is utilized when the user is going away from the premise and wants the interior protected. Listed below
are the steps to arm in the AWAY Mode:
Step 1 Close all protected doors and windows.
• Ready light will be on or flashing when all protected
zones and sensors are secure. NOTE: If any zones are
bypassed, a sensor in that zone can be violated
without affecting the ready light.
• The security system will not arm if the ready light is off.
Refer to "Making the System Ready to Arm" below.
• If the power light is off, you have no AC power. Restore
power if possible. If not, contact your installing company. If the power light if flashing, you
have a battery failure. Contact your installing company.
System Ready
Type Code to Arm
System Not Ready
For help, press
System Armed
All Zones Secure
Step 2 Enter your 4 or 6 digit user code to arm the system.
• The armed and exit lights will illuminate.
• You may now leave the building.
IMPORTANT!
The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that
the exit time is about to expire. The user may wish to disarm and rearm the system if more time is
needed.
Making the system ready to arm
If the ready light is not on or if it is flashing, a zone is not secure. To identify this zone, use the scroll keys []
[] to the right of the display to browse through the zones that are not normal. If you wish to bypass or
unbypass one of these zones, press the [BYPASS] key while that zone is being displayed. When finished
viewing the zones, press the [#] key to return to the code entry screen.
NX-148E User manual Page 8 04/10/04
To Next Page
Loading...
Need help?
General