GE Security
g
KEYPAD CONTROL TONES (BEEPS)
A sounder is built into the keypad and may sound for any of the following reasons:
• Beeps for all keypresses.
• Sounds a continuous tone during the Entry delay time.
• Pulses when a day zone is violated while the system is disarmed.
• Pulses when a FIRE zone has a trouble condition.
• Pulses when the armed status changes and the AC power is off.
• Beeps 3 times for trying to arm with the “READY” light off, if “FORCE ARMING” has not been
selected.
• Beeps 1 second for the ‘CHIME” feature.
• Beeps 1 second at the end of the exit delay.
• Beeps to indicate telephone line fault if selected.
• Beeps during an exit delay; beeps rapidly for the last 10 seconds of an exit delay if selected.
• Pulses when one or more of the following conditions are detected: Zone or Box Tamper, Low Battery,
AC Power Fail, or Expander trouble.
• Beeps 3 times every minute indicating a low battery or missing transmitter is detected (if wireless
device is in system). Entering code will suppress the sounder for 12 hours.
Entering a valid code will silence the keypad sounder when it is pulsing. The arm/disarm state of your
system will not change when entering a code to silence a pulsing keypad sounder. Please contact your
installer if a trouble condition exists.
NX-148E User manual Page 23 04/10/04
To Next Page
Loading...
