GE NX-148E - Unbypassing

GE Security
g
Unbypassing
Step 1 Press the [BYPASS] key.
Step 2 When the LCD prompts for a code (optional, if programmed), enter your user code.
Step 3 The bypass light flashes.
Step 4 Enter the zone number (each time 2 digits) of the zone(s) that must be unbypassed.
(Example: to bypass zones 4 en 5, press [0][4][0][5].)
Step 5 Press the [BYPASS] key again.
Step 6 The bypass light will stop flashing.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.
NX-148E User manual Page 12 04/10/04