GE P643 User Manual

2 Communication Interfaces 316
3 Serial Communication 317
3.1 EIA(RS)232 Bus 317
3.2 EIA(RS)485 Bus 317
3.2.1 EIA(RS)485 Biasing Requirements 318
3.3 K-Bus 318
4 Standard Ethernet Communication 320
4.1 Hot-Standby Ethernet Failover 320
5 Redundant Ethernet Communication 321
5.1 Supported Protocols 321
5.2 Parallel Redundancy Protocol 322
5.3 Rapid Spanning Tree Protocol 323
5.4 Self Healing Protocol 323
5.5 Dual Homing Protocol 325
5.6 Redundant Ethernet Configuration 326
5.6.1 Setting the NIC IP Address 328
5.6.2 Setting the Switch IP Address 328
6 Data Protocols 329
6.1 Courier 329
6.1.1 Physical Connection and Link Layer 329
6.1.2 Courier Database 330
6.1.3 Settings Categories 330
6.1.4 Setting Changes 330
6.1.5 Event Extraction 330
6.1.6 Disturbance Record Extraction 332
6.1.7 Programmable Scheme Logic Settings 332
6.1.8 Time Synchronisation 332
6.1.9 Courier Configuration 333
6.2 IEC 60870-5-103 334
6.2.1 Physical Connection and Link Layer 334
6.2.2 Initialisation 335
6.2.3 Time Synchronisation 335
6.2.4 Spontaneous Events 335
6.2.5 General Interrogation (GI) 335
6.2.6 Cyclic Measurements 335
6.2.7 Commands 335
6.2.8 Test Mode 336
6.2.9 Disturbance Records 336
6.2.10 Command/Monitor Blocking 336
6.2.11 IEC 60870-5-103 Configuration 336
6.3 DNP 3.0 337
6.3.1 Physical Connection and Link Layer 338
6.3.2 Object 1 Binary Inputs 338
6.3.3 Object 10 Binary Outputs 338
6.3.4 Object 20 Binary Counters 339
6.3.5 Object 30 Analogue Input 339
6.3.6 Object 40 Analogue Output 340
6.3.7 Object 50 Time Synchronisation 340
6.3.8 DNP3 Device Profile 340
6.3.9 DNP3 Configuration 348
6.4 MODBUS 349
6.4.1 Physical Connection and Link Layer 350
6.4.2 MODBUS Functions 350
6.4.3 Response Codes 350
6.4.4 Register Mapping 351
6.4.5 Event Extraction 351
6.4.6 Disturbance Record Extraction 352
6.4.7 Setting Changes 360
P64x Contents
P64x-TM-EN-1.3 ix

GE P643 Specifications

General

Brand	GE
Model	P643
Category	Relays
Language	English