5.7.2.2
IP
Address Setting
The QuickPanel
+
Operator Interface provides two methods to set an IP address:
• DHCP (Dynamic Host Configuration Protocol)
The network server assigns an IP address during QuickPanel
+
initialization. There must be a DHCP server on the
connected network for a valid IP address to be assigned. Contact your network administrator to ensure correct
DHCP
server configuration.
• Manual Method
Specify the numeric addresses obtained from your network administrator for the QuickPanel
+
IP Address, Subnet
Mask and Default Gateway (if applicable).
Note Run the Backup utility to save the settings.
To Next Page
Loading...
