GE SecoGear - Page 5

SecoGear – Installation, Operation and Maintenance Manual 5 of 56
Figure 2-1: Recommended Lifting Method (Front View) ........................ 13
Figure 2-2: Recommended Lifting Method (Side View) ......................... 14
Figure 2-3: Corner Warning Label ............................................. 14
Figure 2-4: Placing Forklift Tines under Equipment Shipping Skid ............... 14
Figure 2-5: Moving Using Rollers .............................................. 14
Figure 2-6: SecoVac Vacuum Circuit Breakers .................................. 15
Figure 3-1: Section Contents .................................................. 16
Figure 3-2: Circuit Breaker Manual Rack in/out ................................. 17
Figure 3-3: Circuit Breaker Automatic Rack in/out ............................. 17
Figure 3-4: SecoGear Primary/Secondary Disconnects ......................... 17
Figure 3-5: Circuit Breaker Primary/Secondary Cluster ......................... 17
Figure 3-6: Automatic Shutters ................................................ 18
Figure 3-7: Interlock for Secondary Disconnect Plug Removal .................. 18
Figure 3-8: Open-Close-Open Safety Interlock Plungers .......................19
Figure 3-9: Padlock for Door and Breaker Rack in/out .......................... 19
Figure 3-10: Current Transformers ............................................ 19
Figure 3-11: Voltage Transformers ............................................. 20
Figure 3-12: Fuses-only Tray .................................................. 20
Figure 3-13: CPT with Fuses Tray .............................................. 20
Figure 3-14: Manual Ground and Test Device .................................. 21
Figure 3-15: SecoVac Vacuum Circuit Breaker. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Figure 3-16: Disconnect Finger Cluster ........................................ 22
Figure 3-17: Lift Truck Ready for Use ........................................... 23
Figure 3-18: Remote Racking Operator ........................................ 23
Figure 3-19: Remote Switch Operator ......................................... 23
Figure 4-1: SecoGear Installation Drawing – Indoor Anchoring Method ......... 24
Figure 4-2: SecoGear Primary Indoor Anchoring Method ....................... 25
Figure 4-3: Lineup Shown Assembled ......................................... 25
Figure 4-4: Lift Plugs in Position ............................................... 26
Figure 4-5: Position Wires for Clearance ....................................... 26
Figure 4-6: Front Bolt Locations (left and right) ................................ 26
Figure 4-7: Rear Bolt Locations (left and right) ................................. 26
Figure 4-8: Front Left Trim Covers Installed .................................... 27
Figure 4-9: End Cover Assembly ............................................... 27
Table of Figures