GE SecoGear - Page 7

SecoGear – Installation, Operation and Maintenance Manual 7 of 56
Table of Figures (Cont.)
Figure 5-15: Operation Handle Fully Engaged into Switchgear Compartment ... 39
Figure 5-16: Press Down on the Interlock Pin and Rotate Clockwise to Lock
the Latch Handle ............................................................. 39
Figure 5-17: Unlock VCB from Lift Truck. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Figure 5-18: Lock VCB into Switchgear ........................................ 39
Figure 5-19: Rotate Interlock Pin Counterclockwise to Unlock the Latch Handle 40
Figure 5-20: Interlock Latch Handle ........................................... 40
Figure 5-21: Stop in Proper Position ........................................... 40
Figure 5-22: Eliminating Stop Interference ..................................... 40
Figure 5-23: Release Floor Lock ............................................... 40
Figure 5-24: Release Secondary Plug from VCB ................................ 41
Figure 5-25: Insert Secondary Plug and Lock into Switchgear
Compartment Socket ......................................................... 41
Figure 5-26: Racking Handle .................................................. 42
Figure 5-27: Racking Handle Insertion on Door ................................ 42
Figure 5-28: Access Hole Open ................................................ 42
Figure 5-29: Disconnected/Test Position (Green) ............................... 42
Figure 5-30: Intermediate Position (Yellow) .................................... 42
Figure 5-31: Connected Position (Red) ......................................... 42
Figure 6-1: SecoVac Test Box .................................................. 43
Figure 9-1: Rear Compartment Assembly Illustration .......................... 48
Figure 9-2: CTs mounted in compartment. ..................................... 49
Figure 9-3: CT Spacers, 7/8” (left) and 2” (right) ................................ 49
Figure 9-4: CT Spacers Installed ............................................... 49
Figure 9-5: CT Wire Harness in Compartment ................................. 49
Figure 9-6: CT Wires Connected ............................................... 50
Figure 9-7: CT Installed, Shutters in Open Position ............................. 50
Figure 9-8: SecoGear Manual Racking Port Padlocked. . . . . . . . . . . . . . . . . . . . . . . . . . 50
Figure 9-9: Compartment Door Padlock ....................................... 51
Figure 9-10: Shutter Padlock .................................................. 51
Figure 9-11: Kirk Lock Location in SecoGear ................................... 51
Figure 9-12: Initial Stopper Rod Position ....................................... 52
Figure 9-13: Locked Stopper Rod Position ..................................... 52