GE Senographe DS

Chapter 11 Page no. 122 11-viewer.fm
GE Healthcare Senographe DS Acquisition System
Revision 1 Operator Manual 5307907-3-S-1EN
Viewer
5-1 Layout formats
Layout Formats. Four user-defined buttons show available formats for page
layouts. These are usually: 2x 2,1 x 2, 2 x 1, and 1 x 1.
Select the format desired for the current page by clicking on the appropriate
button.
• If the currently selected printer has been configured to allow more than four layouts, the additional
layouts can be selected in two ways:
- Click the fifth (rightmost) button to display a menu of all page layouts available for the current
printer; select the desired layout from the menu to apply it to the current page.
- The user-defined buttons can be reprogrammed to select different layouts; refer to Options Menu
in section 5-2 Scrapbook functions on page 122.
5-2 Scrapbook functions
Print
Click this button to print all pages of the Scrapbook.
Print Menu
Click this button to display a menu of print options:
• Print page: Prints the contents of the current Scrapbook page.
• Print all pages: Prints all pages of the Scrapbook.
• Printing status: Displays the Printing status panel (see Chapter 13 Printing).
• Printer Configuration: Displays the Print Manager panel.
Options Menu
Click this button to display a two-line pull-down menu:
• Select Options to display a checkbox which allows you to enable or disable the
"delete after print" option.
• Select Layout Preferences to display a menu of all page layouts available for the
current printer. To reprogram one of the user-defined layout buttons (section 5-1
Layout formats on page 122), select the desired format and apply it to the button by "drag and drop".
Delete Menu
Click this button to display a two-line pull-down menu:
• Select Delete Page to remove the current page from the Scrapbook.
• Select Delete All Pages to remove all pages from the Scrapbook.
Options
Layout Preferences
Delete Page
Delete All Pages
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).