Simon XT
User Manual
4
Communicating with your system
Sending commands or instructing your security system is done through a series of key presses on the panel,
touchpads, or a remote telephone.
Note: The default master code is 1-2-3-4 when the security system is shipped from the factory. You should change your code
after your system is installed. See Code options on page 24.
Table 2. System communication devices
Device Description
Control panel You can enter commands for your security system through simple key presses on the panel.
Depending on how your system is programmed, you may need to enter an access code for
certain commands. An access code is a numeric code that allows authorization to operate
your security system.
Remote handheld touchpad This touchpad gives you the option to enter commands from any room in your house. You
can enter commands through simple key presses on the touchpad.
Keyfob Keyfobs are handy for simple arming, disarming and light control functions. They are
portable and can be carried off-site in a purse or pocket.
Telephone Touchtone telephones can be used to communicate with your system while you are off-site.
Ask your installer if you have this feature.
To Next Page
Loading...
Need help?
General
