Simon XT
User Manual
32
Siren options
The panel has two built-in sound sources, a piezo siren and a speaker. The piezo siren makes alarm beeps and
status beeps. Fire and intrusion alarm beeps are always played at high volume, while the volume of status
beeps (such as trouble or chime beeps, entry and exit delay beeps, or auxiliary alarm beeps) is programmable.
The speaker emits the panel's voice and also sounds beeps when a key is pressed. Its volume is also
programmable.
The siren and built-in speaker options consist of the following:
• Panel piezo beeps (status beeps sounded on the siren)
• Panel voice (spoken phrases on the speaker) and key press sounds from the speaker heard while
controlling the system)
• Panel piezo alarms (loud alarms on the siren)
• Status beep volume
• Speaker volume
Piezo Beeps
This option determines whether or not the panel sounds non-alarm beeps.
To program Piezo Beeps:
1. Enter the System Programming menu.
2. Scroll up/down to Siren Options, then press Enter.
3. Scroll up/down to Piezo Beeps, then press Enter.
4. The current value of this option now flashes (On or Off).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Panel Voice
This option determines whether or not the panel speaks status messages and arming level changes.
To program Panel Voice:
1. Enter the System Programming menu.
2. Scroll up/down to Siren Options, then press Enter.
3. Scroll up/down to Panel Voice, then press Enter.
4. The current value of this option now flashes (On or Off).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
To Next Page
Loading...
Need help?
General
