TransPort
®
PT900 Quick-Start Guide
17
9.6 Selecting the Units of Measurement (cont.)
To program the Units of Measurement options, complete the following steps:
1. Move the slide switch at the top of the menu to either
Metric or English to
select the desired PT900 global measurement units system.
2. Based on your selection above, the units for all of the PT900 measurement
parameters will be automatically populated with default units.
a. Some of the parameters have only one units of measure choice
available. The text boxes for these parameters are grayed out, and the
default units cannot be changed.
b. Some of the parameters have multiple units of measure choices
available. The text boxes for these parameters are active, and the
default units can be changed by opening the drop-down list and
selecting the desired units.
3. After you have completed your programming, click the
OK button to save
your choices or click the
CANCEL button to discard the changes.
9.7 Activating Channel 1
Click the Setup Channel 1 button in Figure 13 on page 14 to open the Channel 1
menu shown in Figure 16 on page 18. At the top of the menu, slide the toggle
switch to change the channel status from
Off to On.
To Next Page
Loading...
