Section 4 — Measurement Types and their Uses
102
Automatic sample rate adjustment over varying speeds
Take Order Tracked Measurement
Order tracking can only be applied to Spectrum, Waveform, Coast-
down/Run-up, Demodulation, and Orbit Plot measurements on certain
instruments.
NOTE: By default, the X axis on an order tracked spectra is in
Orders not CPM.
NOTE: Order tracked recordings can also be configured in Ascent.
See the Software Reference Guide for more information.
NOTE: Phase data is not available for order-tracked recordings.
To take an order tracked measurement:
1. Press or Measure.
2. Use ONE of these methods to select the required measurement type:
• Press Spectrum Waveform.
• Press Demodulation.
• Use the arrow keys on the left to select Coast-down/Run-up or
Orbit Plot.
3. Press .
To Next Page
Loading...
