Section 5 — Set Measurement Options
112
Set Measurement Parameters
When you select a measurement type (e.g. Spectrum Waveform from the
Measure menu), the default parameters display.
Default parameters for spectrum measurement setup
To set measurement parameters:
1. Open the main menu.
2. Press Measure > Press Spectrum Waveform.
3. Press to display the hint labels.
4. Press Create New Paramset — The default parameters for a
spectrum measurement display.
5. Press a key beside a parameter value to change it — This will cause
the parameter to cycle through the available options. Alternatively, a
submenu will display, enabling you to enter a value using the
keypad or select a value from the list. Press to save your
changes if you have opened a submenu.
6. Press to display Averaging parameters and Window type.
To Next Page
Loading...
