Section 9 — Working with Routes
182
Enter Machine Speed on Route
The linear or RPM-based speed of the selected machine (as configured in
Ascent or on your instrument) is displayed in the Route screen.
You can configure the machine speed type (RPM-based or Linear Speed)
on the Machine Editor panel in Ascent. To do this, right-click a machine in
the folder tree on the left > Select Edit.
You can only edit the speed value via the instrument interface. If the
machine has been configured to ask users for a speed reading, a
machine speed window will open before location measurements are
taken. You may also manually enter the machine speed at any time. To
do this, select a location > Press RPM or Linear Speed.
NOTE: The Linear Speed window displays the roller diameter and
point multiplier (Point level) specified in Ascent. Speed multipliers
configured in Ascent are applied automatically to all
measurements. However, for RPM-based machines, the multiplier
will be ignored when the measurement is tachometer-triggered.
For linear speed machines, the multiplier will be ignored when a
physical tachometer is configured.
Machine RPM
To Next Page
Loading...
