GE vb8 - Page 87

Section 4 — Measurement Types and their Uses
76
8. Specify the locations and directions for the readings you have
saved:
a. Press Machine Name > Select or specify the machine you
performed the impact test on (e.g. Rotor 1) > Press .
b. Press to specify the reference point you used during the
recording > Press .
c. Press to select the point for the other channel you used >
Press .
d. Press to specify the direction you used for your reference
sensor > Press .
e. Press to specify the direction you used for your other
sensor > Press .
9. Press to save your data and move to the next point, or to
exit.
Taking a Cross Channel Spectrum (ODS) recording