Zero Search
The zero search feature enables the VCR to quickly return to a
counter reading of 0:00:00 anywhere on the tape. This is
especially convenient when you want to repeat a segment of the
tape several times.
1. Go to the beginning ofthe program you wish to return to.
2. Press INFO twice to display the time counter on the TV
screen.
3. Press CLEAR to reset the counter to 0:00:00.
4. Continue playing the tape.
5. Press STOP.
6. Press SEARCH on the remote twice to display the ZERO
SEARCH menu.
7. Press REVERSE to return to 0:00:00 on the tape.
ZERO SEARCH
Current tape counter
2:17:25
Press REV to go to
0:00:00
Press SEARCH to exit
ZERO SEARCH
Searching for
0:00:00
Press STOP to cancel
is
Commercial Scan (SEARCH Button)
This is useful for skipping commercials or short program
segments.
• Press SEARCH once during playback to advance the tape
approximately 30 seconds of recorded material.
• Each press of the SEARCH button adds an additional 30
seconds upto five minutes.
Tracking
Your VCR has automatic tracking which removes the streaks or
snow from the picture. Automatic tracking is activated when you
insert a tape or turn on the VCR. Occasionally you may need to
manually adjust tracking, especially if the tape was recorded on a
different VCR. Just use the TRACKING buttons to remove the
streaks or snow. You can also use tracking when you pause a tape
to reduce jittering of the picture.
When you manually adjust the picture, automatic tracking is
turned off. To turn automatic tracking back on, pr ess both
TRACKING buttons on the front of the VCR at the same time, or
eject the tape and re-insert it. Tracking has no effect during
recording - only playback.
44
To Next Page
Loading...
