EasyManuals Logo

Geeetech A30 Building Instructions

Geeetech A30
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
6
Step 4. Fix the two Z axis stators on two sides of the vertical frame respectively.
Fasten the screws on the stators in a relatively loose way.
Note: Pay attention to the direction of the nuts on the Z axis stator.

Other manuals for Geeetech A30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Geeetech A30 and is the answer not in the manual?

Geeetech A30 Specifications

General IconGeneral
Build Volume320 x 320 x 420 mm
Nozzle Diameter0.4 mm
Filament Diameter1.75 mm
ConnectivityUSB, SD card
Frame MaterialAluminum
Printing TechnologyFDM (Fused Deposition Modeling)
Heated BedYes
Supported FilamentsPLA, ABS, PETG
DisplayLCD
Power Supply24V
Bed TemperatureUp to 110°C
Nozzle TemperatureUp to 250°C
Printing PlatformRemovable glass platform

Related product manuals