GEEETECH
- 2 -
SAFETY INSTRUCTIONS
It is easy to build Geeetech A30, since it comes almost fully
assembled. We have provided detailed instructions to help you
assemble it easily. Please make reference to the Quick Start Guide.
However, ultimately we cannot be responsible for your health
and safety whilst building or operating the printer, with that in mind
be sure you are confident with what you are doing prior to
commencing with building or buying. Read the entire manual to
enable you to make an informed decision.
Building and operating involves electricity, so all necessary
precautions should be taken and adhered to. The printer runs on 12V
supplied by a certified power supply, so you shouldn’t ever have to
get involved with anything over 12V. Please bear in mind there can
still be high currents involved even at 12V.
High temperatures are involved with 3D Printing. The Extrusion
nozzle of the hot end can run at about 230°C, the heated bed at about
110°C and the molten plastic extruded will initially be at around
200°C. Therefore, special care and attention should be made when
To Next Page
Loading...
Need help?
General
