GEEETECH
- 9 -
GENERAL CARE AND MAINTENANCE
As with all the electronic equipment, it is important to keep your
printer clean to extend its life. Regularly remove dust and debris with
a microfiber cloth or compressed air. Dredge the tube and the nozzle
after use every time to ensure fluent performance.
Don’t leave the heaters on the printer turned on for a long
periods of time when not used.
Don’t leave your printer in shady and moist places, which may
exacerbate the problems associated with erosion.
The three axes of the GEEETECH A30 are lubricated with
grease for smooth operation and can last for a long time.
Grease may need to be re-applied to your printer to maintain
smooth performance.
Avoid positioning your power supply unit in such a way that
the brick is hanging, pulling, or putting any unnecessary
stress in the electrical wires and components.
To Next Page
Loading...
