2.Press the BND button to choose a wave band
among FM1 FM2 FM3 MW1 and MW2.
The function of auto seek station is available
on“SEEK 1”and“SKKE 2”.
3.press the left knob more than 1 second to
enter into the mode of choosing. Press the
button again to choose“SKKE 1”from DSP
OFF/ESP12/MULT OFF/BEEP ON/SKKE 1.
4.Screw the left knob to choose“SKKE 1”or“SKKE 2”.
5.On SKKE 1
Press button or screw the right knob toward
right (left) side to seek stations. The frequency
band will increase or decrease step by step, and
will stop when a station is searched.
The time starts at 0:00 in default when
power on.
The format of time is 24 hours.
1.Press the CLK button, the time displays on LCD.
2.press and hold the CLK button (over 1 second),
the “hour”and “minute”will ash in LCD.
3.srew the knob toward the left side to adjust
the “minute”, and toward the right side to
adjust the “hour”.
4.it will return the foregone status after 5
seconds without any operation.
5.display the time when working:
Press the CLK button to display the time, press again
to cancel. the longest time of display is 5 seconds.
6.the time will keep on display on LCD after power off.
Radio operation
The frequency ranges of FM1 FM2 and FM3
are identical (87.5-108MHz).
The frequency ranges of MW1 and MW2 are
identical (522-1620KHz).
If turn off during radio receiving, and turn on
again, it will still stay on the former frequency.
If FM broadcasting in stereo and the signal is
good, the indication sign “ ”will light on.
Auto seek station
74
Part I
To Next Page
Loading...
