Auto preset station
1. press the BND button to choose a wave band
among FM1 FM2 FM3 MW1 and MW2.
2.press the right knob more than 2 seconds to
preset station automatically. The presetting
starts from the lowest frequency. During the
course, the frequency changes quickly with the
character “ ”ashing on the screen. Press again
to stop the presetting.
Maximum 6 stations can be preset in each
wave band, and the station with stronger signal
will be preset preferential.
It will scan-play all preset stations, then play
the station which corresponding to the button 1.
6.On SKKE 2
Press ( )button more than 0.5 second or
screw right knob toward right (left) side to
seek stations. The frequency band will increase
or decrease step by step, and will stop when a
station is searched. If press and hold the button
scan will continue until loose the button, then
scan will stop when a station is searched.
7.Scan will stop if and operations on the
( )
button.
Manual seek station
1.Press the BND button to choose a wave hand
among FM1 FM2 FM3 and MW2.
2.Press ( )button or screw the right knob
toward right (left) side to adjust frequency.
One adjusting step of FM is 0.1 MHz, AM is
9KHz.
Preset again on the same wave band, the
formerly preset stations will be replaced.
Manual preset station
1.Press the BND button to choose a wave band
among FM1 FM2 FM3 MW1 and MW2.
2.Press ( ) button or screw the right knob
toward right (left)side to preset a station.
75
Part I
To Next Page
Loading...
